openUC2 Xiao AI Microscope Troubleshooting )

Flashing the ESP32S3 in case the bootloader is not responding

Sometimes - with a wrong firmware, one can not simply flash a new firmware. One has to press the boot/reset buttons to bring the ESP32S3 xiao into boot mode. It's a bit unfortunate that there is no workaround to do that via Software. So we would need to access the tiny buttons of the MCU. For this we have to open the device. Don't worry, it's doable and worth it! According to seeed studio, there is no way to determine when the firmware can easily be flashed or needs a manual enter into the bootloader.

Open the device by unscrewing all panels using philips screwdrivers

remove the lens (optional)

all panels removed

unscrew the side where the z-stage remains

this is the camera module, remove the z-stage

we need to access these two philips screws and remove the camera module from the backplate

this is the camera module, remove the cooling body

remove the cooling body with these two screws

*carefully remove the cooling body and access the xia. Now you can flash it according the manual in the Xiao Tutorial

**Ensure the firmware runs, then put everything back together again. If you have questions visit our forum: https://openuc2.discourse.group

Changing the Objective Lens

The device has a finite corrected microscope lens with an RMS thread. The design of the z-stage offers to change the lens. The mechanism has a little cap that holds the lens in place. This has to be unthreaded. Unfortunatley this is not very easy to accomplish with a closed enclosure. You simply need to remove the side plates and unscrew the cap to free the lens. The images below will help you to do so:

Remove screws on both sides